A special pop rivet gun or tool pulls the mandrel head into the body of the rivet, which then expands against the blind side of the join. Activate the tool usually by some lever or trigger mechanism to pull the mandrel towards the surface.
After ensuring one piece of rivets loaded on the gun nozzle of the rivet gun, hold rivet gun on one hand, hold the workpiece on the other hand and align the riveting point to perform the riveting operation.
Apply a gentle pressure to the handle of the tool, in order to keep the rivet in place, and then push the. Apply the pliers on the exposed needle stub. Look for these fittings and add oil to them. Lubricating the interior of the gun is very important for proper functioning.
Now, for wood or leather, you need to make sure to use rivet washers. Place the rivet installation tool on the mandrel of the rivet.
Preparing the rivet gun for work. Press the handles together several times until the pin on the blind rivet is clipped off. Press together the blind riveter handles slightly with the blind rivet in the nozzle to hold it in place. Push the metal rivet into the tool as far as possible, so that the rivet is resting on a chuck at the back of the gun.
Release the trigger so that the rivet is held in place. Start by drilling a hole that will fit the rivet nut. Take a rivet and place it into the pop rivet tool with the pin shape towards the tool. The hrr rivet gun by teng tools is the perfect device for those searching for a rivet gun that can be used for industrial and construction applications. The machine will automatically send one piece of rivets to rivet gun nozzle, then wait for the next riveting operation.
The pin and the rivet. The rivet gun pin die then slots over the pin or mandrel and when the handles are squeezed, pulls the pin through the rivet which then deforms forming a dome on the underside, joining the two surfaces together. The rivet is then inserted into the hole from one side, and a rivet puller commonly referred to as a rivet gun is used on the same side to pull on the rivet stem.
The riveter works like a jack, push it flat to the bottom of the rivet and squeeze as many times as you need to get it to snap off. The thin end goes in the gun and the fat end goes through your material. The Arrow Rivet Tool is made from steel and has vinyl hand grips. The nose piece can be interchanged to accept different sizes of rivets. Rivets can be used to fasten gutters and downspouts, sheet metal heating and air conditioning ducts, or other metal or automotive applications.
The main advantage to using rivets is that you can fasten two pieces of metal together without needing access to the rear of the work. Measure the thickness of the work to be fastened, and choose a rivet for your job that has a thicker grip range than this thickness. Drill a hole into the work using a power drill with the correct size of drill bit installed.
The grip range is the thickest part of the rivet that the rivet tool expands into your drilled hole, holding the work together. Match the diameter of the hole in the nosepiece to the outside diameter of the narrowest part of the rivet you are using. Insert the narrower end of the rivet into the nose piece. Use the nosepiece that the rivet fits into snugly. Change the nosepiece by squeezing the handles of the tool together and backing out the present nosepiece with an adjustable wrench.
Thread the correct size of nosepiece onto the tool and tighten in a clockwise direction. Release the handles. Open the jaws of the rivet tool and insert the rivet into the nose piece of the tool.
0コメント